It is very likely that the cause of the Aftershokz not charging is the dead battery. In some cases, we use our headphones for an extended period of time, and then after a few warnings about battery low, they switch off automatically. In those instances, we put them on charging and try turning them back ON as soon as possible. In this case, the battery can be dead and you may have to replace the battery.

In this article, I am going to give you some recommendations on how you can avoid Aftershokz not charging problems. After reading this article you don’t have to look further.

Let’s get started!

Aftershokz Not Charging: Solutions and Recommendations

Following are the most tested solutions and recommendations to avoid Aftershokz not charging issues.

When your headphones are close to 0% battery life, it is suggested that you do not use them. Secondly, if you have done that, then do not try to switch ON the headphones right away after putting them on charging.

If the battery has not been charged even after a long period of time, then it is recommended that you use a powerful charger(Not more than 5 volts and 2 amp) for some time and then put the device on the regular charger.

You can also try to use another magnetic charging cable to charge your headphones to figure out if the previous one is working.

Another option is to contact the manufacturer for assistance. You can also file a warranty claim if the problem still persists.

Lastly, you should also look at the electric socket. It is a rare possibility that the socket is damaged. You should change the socket just to ensure.

How to charge Aftershokz Properly?

Your AfterShokz headphones will be 50 percent charged when you unbox them (normally, but vary). It will take about one hour for them to reach 100 percent.

A micro USB cable can be used to charge most of the Aftershokz bone conduction headphones, but any micro USB cable will work just fine. So, don’t hesitate to charge them with any other micro USB cable to keep one safe for future use.

You can find the charging port under the protective rubber flap that is located on top of the headphones. Firstly, you will need to remove the protective rubber flap from the port in order to insert the cable into it.

You can use either the USB end of the device with a computer or a USB wall charger. However, keep in mind, you cannot charge the device above 5 volts and 2 amps at a time.

The LED light will turn blue as soon as it is fully charged.

Keep the protective rubber flap on the charging port of your headphones secured in place so that your headphones are protected from any damage, moisture, or debris.

If your headphones are wet or have sweat on them, it is important to allow them to air dry before you start charging them.

For more information regarding Aftershokz Not Charging, you can also contact Aftershokz’s customer service department for more assistance.

You can also read our guides for:

  1. How to turn on Aftershokz Headphones
  2. Aftershokz Troubleshooting
  3. Aftershokz Not Turning ON
  4. Aftershokz Multifunction Button Not Working
  5. How to Wear Aftershokz with Glasses
  6. How to Claim Aftershokz Warranty

Some of our Recommended Aftershokz Bone Conduction Headphones

Similar Posts